Then draw lines connecting those middle points. Then using the draw line tool again, mark out vertical and horizontal divisions by starting in the corner by measuring out half of the distance and draw the line. The center would be the intersecting point. An easy way to do this is to use the Draw Line Tool and draw 2 lines from corner to corner. A grid is very useful at identifying the initial quarter divisions. The last number is the largest area excluding the section itself and the one to start identifying, North east quarter. The easiest way to decipher and map these is from back to front. It is read the west half or the west half of the east half of the North east quarter. Section 4 W 1/ 2W 1/ 2E 1/ 2NE 1/ 4 - This is an expansion on the previous example.Section 3 S 1/ 2NE 1/ 4 - When there is a back to back direction and fraction with no comma in between them, it is read the South Half of the Northeast quarter of section 3.Section 2 S 1/ 2 - This is simply stating that it is the south half of that particular section 13.It is simply stating that that property is the entire section 24 of the Township and Range given previously. Section 1 All - This one is probably the most basic description and the easiest to map.Township-Range + Fractional Designation aka Block Survey aka Rectangle Block Survey With this page I will attempt to make sense of some of the formats commonly used.ġ. To learn more about these land descriptions, view our Real Estate Principles course, which provides information on ethics of practice, titles to and conveyance of real estate, deeds encumbrances and liens, distinctions between personal and real property, appraisal, finance and regulations, and more.When determining boundaries for a section of owned ground, the written legal description of the borders can vary in format and wording. The three legal real estate land descriptions are important information that all real estate agents and brokers must understand to pass their real estate exam and receive their license. Lot _ Block _ of Subdivision _ in the County of _, State of _. The Lot and Block (or Recorded Plat) System has a map showing lot dimensions approved by the Board of County Commissioners. It is sometimes referred to as the recorded plat survey system, or the recorded map survey system. The lot and block survey system is a method used in the United States and Canada to locate and identify land, particularly for lots in densely populated metropolitan areas, suburban areas, and exurbs. Recorded Plat Survey System (Lot and Block Survey System) For example, an object to the East would have an absolute bearing of 90 degrees. The Bearing System uses degrees, minutes, and seconds for measurement and describes the angle between true north and an onjecy. Additonally, Metes and Bounds uses the Bearing System. Metes are a measure of length and bounds are boundaries. Metes and Bounds are a legal real estate land system used to describe irregular parcels and plated subdivisions. Quadrangles → Townships → Sections → Parts 2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |